Remapping the Renault Wind (2010), 1.2 TCE 100HP.
Remapping the 1.2 TCE 100HP in the Renault Wind (2010) lifts torque from 152Nm to 195Nm, a 28.3% increase that noticeably outpaces the 22% gain in BHP (100 to 122bhp).
As a naturally aspirated petrol, gains are more modest by nature, and this transformative improvement is best appreciated as sharper throttle response rather than a transformed power band. These figures apply to 2010 models.
Typical remap gains for the Wind 1.2 TCE 100HP
Standard vs Remapped
Standard vs Remapped
- Power: 100bhp standard, 122bhp after a Stage 1 remap.
- Torque: 152Nm standard, 195Nm after a Stage 1 remap.
- This is a torque-led gain: pulling power increases by more than BHP, which is felt mainly as a stronger mid-range.
- This is a naturally aspirated engine, so headroom beyond Stage 1 is limited compared with a turbocharged equivalent.
- As a petrol engine, the practical benefit is mainly felt as sharper throttle response and a broader power band.
- These figures apply specifically to 2010 models.
- These are Stage 1 figures only, achieved without any hardware changes.
Questions about remapping your Wind 1.2 TCE 100HP
How much power and torque does a Stage 1 remap add to the Renault Wind (2010) 1.2 TCE 100HP?
A Stage 1 remap typically takes the Renault Wind (2010) 1.2 TCE 100HP from 100bhp to around 122bhp, and torque from 152Nm to around 195Nm. This is a transformative gain achieved entirely through software, with no hardware changes required.
Is the Renault Wind (2010) 1.2 TCE 100HP a good candidate for remapping?
Generally, yes: as a naturally aspirated engine its headroom is more limited, though a well-executed remap can still sharpen throttle response, and the transformative gain shown here reflects that. The main caveats are condition, not the engine itself, a healthy service history, no outstanding fault codes, and (for diesels) a clear DPF and EGR are what actually determine whether this particular car is ready for a remap.
Will remapping affect the warranty on my Renault Wind (2010)?
A manufacturer can only void the parts of a warranty that the remap directly affects, not the entire vehicle, under the Consumer Rights Act and EU Block Exemption principles. In practice, on a Renault Wind (2010) 1.2 TCE 100HP this usually means engine and transmission-related claims are the ones worth discussing with a reputable tuner before booking.
What should I check before booking a remap for my Renault Wind (2010) 1.2 TCE 100HP?
Before booking, confirm the tuner uses a custom or bespoke file rather than a generic off-the-shelf map, ask whether they do a pre-remap health check, and check service history and mileage on your specific Renault Wind (2010).
What's the difference between a Stage 1 and Stage 2 remap for the 1.2 TCE 100HP?
Stage 1 is software-only and is what the figures on this page reflect. Stage 2 builds on that, but on a naturally aspirated engine like this, the scope for a Stage 2 remap is limited, since there is little forced induction to work with, so it is a separate conversation with a tuner rather than an automatic next step.
Will remapping my Renault Wind (2010) affect my insurance?
Yes, always, a remap is a modification and must be declared to your insurer regardless of size. Given this transformative gain on the 1.2 TCE 100HP, expect a likely premium increase, and it is worth getting a quote from a specialist modified-vehicle insurer before booking the remap itself.